Shopping Cart 
Checkout
Knowledgebase
Key Blank Identification
Posted by Joe L on 08 August 2012 03:09 PM

Key Blank FAQs:

 

Profile image shown under key blank: The profile is used as if you were inserting the key into the page of the book, or inserting your key into the computer screen - See Image below:

Key Blank Image  Using Key Blank Profile

 

Reverse Millings: JMA and Ilco both have various ways to represent reverse millings. As shown in the image above the JMA reverse milling on the HOND-19D.P would be HOND-19.P (with or without the D would be reverse millings of the same key blank). Ilco will usually (but not always) append an R to the end of the key such as 1646, and 1646R representing reverse millings.

 

JMA Key Blanks    Ilco Key Blanks

(0 vote(s))
This article was helpful
This article was not helpful

Comments (0)
Post a new comment
 
 
Full Name:
Email:
Comments:
CAPTCHA Verification 
 
Please enter the text you see in the image into the textbox below. This is required to prevent automated registrations and form submissions.

Help Desk Software by Kayako Fusion